Blog
The Jeffrey 2.69, How to Flat Solder, Balance to 25 degrees using Solder Pad Weights
Check out this video where I take you through the new features of The Jeffrey 2.69, show you an flat soldering technique, and balance this iSpindel to 25 degrees using a new method.
iSpindel Troubleshooting and Known Issues
D1 Mini Issue: iSpindel has been flashed with the firmware and everything appears to have completed successfully. However, the iSpindel doesn’t show up as a wifi network while in configuration mode and therefore the access point is unavailable. Possible Reasons: Read more
iSpindel Serial Monitor
Why use a serial monitor? If you are having an issue with your iSpindel the serial monitor is a quick diagnostic tool you can use to see what’s going on behind the scenes. It can display error messages that give Read more
Sugar Wash Recipe Design #3
If you want to see the video from Sugar Wash Recipe Design #2 click on this link. This recipe is the same with a few slight differences. Only 1 to 2 gallons of hot water instead of 2.5 gallons (the Read more
Ubidots for iSpindel
Change Accuracy in Graphs to Three Decimal Places If you are using specific gravity for your iSpindel you’ll need to change your defaults in Ubidots to support three decimal places. Click on your top right profile picture and select My Read more
Podcast and 1,000 Subscribers – Giveaways!
Click here for the link to the HomeBrewingDIY.beer podcast I did. Facebook Page found here. Facebook Group found here.
iSpindel 25° Calibration in Pure Water
Who says we need to do this? I’m not exactly sure the exact inner workings of the iSpindel code that make this necessary, but universam1 who runs the iSpindel GitHub page says it’s not an option, it’s a requirement. I’ve Read more
Liebig Extension – 5″ to 36″
If you are interested in the making of the 5″ Liebig click here. If you are interested in the stripping run video in which the 5″ Liebig condenser was used, click here. If you want to make life easier for Read more
iSpindel Assembly
Shopping List Why People Remove the Diode on the D1 Mini If you don’t remove the diode from the D1 mini you could end up in trouble. When you plug in the D1 mini you are also sending 5 volts Read more